Work Day 18th November 2017

LCP
The simulator was run up and remains serviceable. Ran for a couple of hours before shutting down.

T86
Last week the pedestal drive chain slipped when trying to raise the pedestal so this Saturday Neil re tensioned the chain and raising and lowering the pedestal now works a treat. Raising and lowering the pedestal has to be carried out manually, a task greatly improved with the acquisition of a ½” drive ‘speed brace’ courtesy of eBay and Dave for sourcing the correct size, square, socket. Accompanying photos show the drive chain and the speed brace in action.

Tx Pedestal Chain Drive wm.jpg

Tx Hand Crank Pedestal Gear Box wm.jpg

Pete H set to and completed the paint removal and rubbing down the aerial assembly’s Rx cover, a task started by Richard. A heat gun was used to remove the top coats which literally peeled away as shown in the accompanying photo.

T86 Rx Cover 1 wm.jpgThe The Rx cover now awaits priming and a top coat. As always it is the preparation for a repaint that takes time.

T86 Rx Cover 2 wm.jpg
With the pedestal raised once more it was back to replacing the floor in the rear of the cabin, a jigsaw of sections, hand crafted to fit. The accompanying photo shows the large centre floor section fitted. Removing the last remains of the original rotten plywood was also carried out ready for continuing the manufacturing and fitting of the new floor sections.

Tx Floor Rear of Cabin wm.jpg

With the pedestal raised once more it was back to replacing the floor in the rear of the cabin, a jigsaw of sections, hand crafted to fit. The accompanying photo shows the large centre floor section fitted. Removing the last remains of the original rotten plywood was also carried out ready for continuing the manufacturing and fitting of the new floor sections.